Matsui PRINTGEN MG Slow Drying Additive
Details
Matsui PRINTGEN MG
Slow Drying Additive for Eco-Series waterbase inks. This is added to any waterbase ink to slow (retard) the thickening of the ink while printing. This may also be used as a thinner (reducer) to loosen up the ink so it prints easier. Add .5-25% to slow down the drying time.
CAUTION: Use sparingly and only when needed. Adding too much will extend the drying time needed thru the dryer to achieve full cure.
All Matsui inks are sold "by the pound". The following are approximate container sizes:
- ½-¾ lb = 1 pint
- 1-1½ lb = 2 pints
- 2-3 lbs = 1 quart
- 9-12 lbs = 1 gallon
- 45-55 lbs = 5 gallon pail