Epson 1400/1430 Refillable Cartridges, Set of 6 (EMPTY) T079

Epson (compatible) 1400,1430 Refillable Cartridges HIGH YIELD Set of 6 (EMPTY)

Set of 6 "HIGH-YIELD" cartridges for the Epson 1430 inkjet printer.  These cartridges have auto-reset chips and higher ink capacity.  Basically that means they will last you for the life of the printer!  Simply refill over and over again with your favorite ink (use our POSITIVELY BLACK inkjet ink for film positives).  These are HIGH-YIELD cartridges that hold about 15cc's of ink in each.  Initial filling takes approximately 100cc's on ink for the set.  Make sure you have enough ink on hand.

Compatible with Epson Cartridge # T0791-T0796

INSTRUCTIONS:

Fill all 6 cartridges with your favorite ink first (follow "refilling" instructions)

1. First time use: Start with FULL CARTRIDGES
2. Perform "ink cartridge replacement" menu on your printer
3. Remove the clear plug from the breather hole on each cartridge
4. Insert ALL 6 CARTRIDGES into your printer
5. Wait 10 minutes for ink to settle into printhead
6. Perform 1-3 Cleaning Cycles to load all ink
7. Start printing and saving $

REFILLING:

1. Refill only the cartridge that the printer has flagged as "empty"
2. Perform "ink cartridge replacement" menu on your printer
3. Remove empty cartridge
4. Remove color coded plug
5. Fill with 10-15cc's of ink
6. Replace color coded plug
7. Re-insert filled cartridge
8. Start printing
9. "Auto Reset Chip" will reset when cartridge gets down to 10% full

Troubleshooting Refillable Cartridges:
Question: My refillable cartridges are not being recognized by my printer.
Answer: Make sure that all of our cartridges are installed as a set. These cannot be mixed with store bought/original cartridges. Remove clear rubber plugs. Remove and re-install, pressing firmly until they all click into place. Keep printer on while doing this.

Question: My refillable cartridges are not printing.
Answer: Make sure that the clear rubber plugs have been removed from the breather hole. OR, that the yellow tape is removed when cartridges are used first time.